Mit dieser zusätzlichen freien Zeit habe ich beschlossen, einige Projekte rund um das Aquarium zu machen.
Gestern habe ich diesen Ständer für meinen Abschäumer gemacht.
Normalerweise stelle ich meine mechanischen Teile aus Polyethylen (PETG) her, aber ich hatte kein rotes PETG und war mir nicht sicher, ob ich noch genug weißes PETG auf der Rolle hatte, also habe ich vorläufig rotes PLA verwendet.
Anekdotenweise verwenden andere ohne weiteres PLA im Aquarium, und es ist strukturell für diese Anwendung als Prototyp ausreichend, aber ich kann es immer noch durch PETG ersetzen. (Einige haben Bedenken gegen die langfristige Verwendung von PLA im Aquarium, weil es ein "Biokunststoff" ist)
Wenn ich kritisch bin, dann sehen die Schichtlinien bei dieser roten PLA ein wenig ausgeprägt aus, vielleicht war ich etwas zu heiß. (Ich verwende PLA nicht so oft) Ansonsten bin ich mit dem Ergebnis zufrieden.
English
With this extra free time we have I decided to do a few projects around the aquarium.
Yesterday I made this stand for my skimmer.
I normally make my mechanical parts out of polyethylene, (PETG), however I did not have any red PETG and wasn't sure if I had enough white PETG left on the roll, so I used red PLA for the time being.
Anecdotally speaking, others use PLA in the aquarium with no issue and it is structurally sufficient for this application as a prototype, however I still may replace it with PETG. (Some have concerns about using PLA in the aquarium long term because it is a "bioplastic")
If I'm being critical he layer lines look a little pronounced with this red PLA, perhaps I was a little too hot. (I don't use PLA that often) Otherwise I am pleased with the result.