Bedienungsanleitung Arcadia 3 Series

Hi, hier zumindest mal eine englische Anleitung. Damit sollte e sgehen, ist ja keine "Rocket Science"
Gruß,
christian

Setting the correct time

1) Press Reset button using pencil or similar narrow object
2) Press and Hold the key
3) Use “h” key to set hours
4) Use “m” key to set minutes
5) Use “day” key to select correct day of the week – 1 is Monday, 2 is Tuesday etc.
6) Release “ ”key
7) A flashing “:” should appear between the hours and the minutes on the display.

Setting switching times

1) Press “Prog” key until “-- : --“ is displayed on screen
2) Press key for channel being selected – Channel 1 controls metal halide lamps, channel 2 controls fluorescent tubes
3) If setting switch on time press channel key until appears – If setting switch off time press channel key until appears
4) Set time for switching action to occur using “h” and “m” keys as above
5) Store the set time by pressing “Prog” key.
6) Repeat this process for each switching on or off action to take place during the day, and for each channel.

If you are intending the same sequence to be repeated each day, then your timer is now programmed.

Daily variations

If you do not wish the same cycle to be repeated each day then carry out the following

1) Use the “day” key to select any day which is to be deselected
2) Confirm this with the “Select” key
3) Press the “Day” key again, and that day is now deselected
4) Program switching times for that day using the above procedure
5) Repeat this for any day which is to be deselected, and reprogrammed

Changing switching times

1) Press the “Prog” key until the function to be altered is displayed
2) Enter the new data as already described

Deleting individual switching functions

1) Press the “Prog” key until the function to be deleted is displayed
2) Use the “h” and “m” keys until the display shows “-- --“
3) Press the clock key and hold for 3 seconds

Manual switching

At any time the lights can be switched on or off manually, by pressing the relevant channel key.
This does not affect any preprogrammed functions.